Kyocera TASKalfa 2551ci, Service Manual

Page: 328 / 756

2NP-5
1-4-21
1040 PF lift motor 2 error
(paper feeder)
After cassette 4 is inserted,
PF lift sensor 2 does not turn
on within 15 s. This error is
detected five times succes-
sively.
Defective bottom
plate elevation
mechanism in the
cassette. Check to see if the bottom plate can move
smoothly and repair it if any problem is
found.
Defective connec-
tor cable or poor
contact in the con-
nector. Reinsert the connector. Also check for conti-
nuity of the connector cable. If necessary,
replace the cable.
PF lift motor 2 and PF main PWB
Defective drive
transmission sys-
tem of the PF lift
motor 2. Check if the gears rotate smoothly. If not,
grease the bushes and gears. Check for
broken gears and replace if any.
Defective PF lift
motor 2. Replace the PF lift motor 2.
Defective PWB. Replace the PF main PWB (Refer to the ser-
vice manual of the paper feeder).
1100 PF lift motor 1 error
(large capacity feeder)
After cassette 3 is inserted,
PF lift sensor 1 does not turn
on within 23 s. This error is
detected 5 times successively.
(Time to detect is 2 seconds
at the second time and later.)
During driving the motor, the
lift overcurrent protective
monitor signal is detected for
1s or more 5 times succes-
sively. However, the first 1 s
after PF lift motor 1 is turned
on is excluded from detection.
Paper feeder lift
base elevating
mechanism
Check that the cassette base can be
manipulated smoothly, if not, repair or
replace.
PF Lift motor1 1. Check that the cassette base has been
ascended.
2. Check the drive gear can rotate or they
are not unusually loaded and, if
necessary, replace.
3. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
PF Lift motor 1 and PF main PWB
4. If the wiring is disconnected, shorted or
grounded, replace the wiring.
5. Replace the PF lift motor1.
PF Lift sensor1 1. Check that the sensor is correctly
positioned.
2. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
PF Lift sensor 1 and PF main PWB
3. If the wiring is disconnected, shorted or
grounded, replace the wiring.
4. Replace the PF lift sensor1.
PF main PWB
Replace the PF main PWB (Refer to the
service manual for the paper feeder).
Code Contents Causes
Check procedures/
corrective measures