Kyocera TASKalfa 2551ci, Service Manual

Page: 377 / 756

2NP
1-4-70
9080 LED fault detection
A block is existent below a
peak which was obtained by
activating the LEDs in the four
CIS blocks at power on, which
is less than 80hex.
DP CIS
1. Execute CIS automatic original
document alignment by U411 (see page
1-3-134).
2. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
CIS and DP SHD PWB (YC2)
DP SHD PWB (YC1) and DP main PWB
(YC10)
3. If the wiring is disconnected, shorted or
grounded, replace the wiring.
4. Replace the CIS and execute U411.
DP SHD PWB Replace the DP SHD PWB.
9100 Coin vender control PWB
error
Communication error has
been detected at the coin mec
of the coin vender control
PWB.
Defective coin
vender control
PWB. Replace the coin mec.
9110 Coin vender error
Communication error has
been detected in connection
with the coin mec and the
rejector.
Rejector installed
incorrectly. Check the rejector is properly installed and,
if not, perform the corrective action.
Defective rejector. Replace the rejector.
9120 Sensor error in coin vender
change (Yen 10)
Change is empty despite
change is enough.
Coin jam in the
change tube Check visually and remedy.
Poor contact in the
connector. Check if the change empty sensor is intact.
Defective change
empty sensor. Replace the coin mec.
Defective coin
vender control
PWB.
9130 Sensor error in coin vender
change (Yen 50)
Change is empty despite
change is enough.
Coin jam in the
change tube Check visually and remedy.
Poor contact in the
connector. Check if the change empty sensor is intact.
Defective change
empty sensor. Replace the coin mec.
Defective coin
vender control
PWB.
Code Contents Causes
Check procedures/
corrective measures