KUNBUS-COM EtherCAT
7 / 135
2.3 General Safety Guidelines
DANGER
Danger of electric shock
If unsuitable power supply is used, this can cause an electric shock.
Ø
This can cause death, serious injuries and material damage to your
systems and modules.
è
Only use a power supply that complies with the regulations for safety
extra-low voltage (SELV) or protective extra-low voltage (PELV).
CAUTION
Fault due to mechanical load
A continuous mechanical load of over 5 G or shock loads of over 15 G can
cause faults on your modules.
è
Comply with these load limits and avoid any unnecessary loads.
CAUTION
Fault due to missing or unsuitable spacer bolt
Incorrect or missing spacer bolts can result in high mechanical loads on
your module and control board. This can cause faults.
è
Always use spacer bolts suitable for the connector height of the circuit
board so that the module does not lie on the circuit board.
You can find detailed information in section "Spacer bolt [
}
9]"
CAUTION
Damage due to subsequent processing
Avoid subsequent processing of theCOMS-Modul.
Ø
Soldering can cause components to become detached and thus
damage or destroy the module.
Ø
Please note that the warranty shall become invalid if the products are
changed technically.
è
Speak to your contact person at the KUNBUS GmbH about customised
solutions.
2.4 Environmental Conditions
Operate the COMS-Modul only in an environment that complies with
the operating conditions in order to prevent any damage.
Suitable Environmental Conditions:
Operating temperature
0 to +60°C
Humidity
0% not 95%, non-condensing
Safety Guidelines
