Kubota Z751KWi, Operator'S Manual

Page: 50 / 102

ACCESSORY
1. 12 V electric power socket
You may use the 12 V electric power socket to connect
an auxiliary light or other devices.
• A 12 V outlet is on the right-hand fender. An
electrical charger or other device may be connected
to this outlet.
• The outlet and plug are only powered when the key
switch is at the “ON” or “START” position.
• Do not connect any electric devices that draw more
than a total of 62 W (watts) to these power outlets.
The battery may discharge very rapidly, or the
outlet or plug may fail.
• Maximum allowable W with LED light kit is 48 W.
IMPORTANT :
• Do not use the outlet as a cigarette lighter.
• Do not use the outlet or the plug when it is wet.
• Make sure that the outlet cap is closed when the
outlet is not used.
(1) 12 V electric power socket
TRANSPORTING THE MACHINE
• To transport the machine on a trailer:
– Turn the fuel valve to the “OFF” position.
– Fasten the machine to the trailer.
• Do not attempt to tow this machine, or damage to
the transmission may result.
• When trailering the machine over a long distance:
– Move the mower lock lever to the “UNLOCK”
position.
– Make sure to lower the mower to the 25.4 mm
(1 in.) cutting height by using the mower lift
pedal.
• When transporting the machine under its own
power:
– Move the mower lock lever to the “LOCK”
position.
– Make sure to lift the mower to the top position
by using the mower lift pedal.
• When transporting, make sure all local state and
federal transport laws are met.
(1) Mower lock lever (A) “LOCK”
(B) “UNLOCK”
1. Hydrostatic transaxle bypass
lever
DANGER
To avoid serious injury or death:
• Do not use bypass levers on or around slopes.
The machine can run away and cause injury or
death easily.
IMPORTANT :
• Do not push the machine without rotating the
bypass levers, or transmission damage may
occur.
• Never rotate the levers with the engine running.
1. From the front of the transaxle, rotate the bypass
lever to the right.
Do this for both transaxle (LH and RH).
See the figure below.
(1) Bypass lever (R) “ROTATE THE LEVER TO
THE RIGHT”
2. After moving the machine, rotate both the right side
and left side bypass levers completely to the left.
ACCESSORY OPERATING THE MACHINE
Z751KWi,Z781KWi,Z781KWTi
45