Kubota Z751KWi, Operator'S Manual

Page: 34 / 102

(1) Parking brake pedal
(2) Parking brake lock pedal
(3) Right foot
3. Make sure that the PTO switch is in the
“DISENGAGED” (OFF) position.
(1) PTO switch (A) “ENGAGED” (ON)
(B) “DISENGAGED” (OFF)
4. Place the motion control levers in the “NEUTRAL
LOCK” position.
(1) Motion control lever (LH)
(2) Motion control lever (RH) (A) “NEUTRAL LOCK” position
(B) “NEUTRAL” position (held by
hands)
(C) “FORWARD”
(D) “REARWARD”
5. Set the throttle dial as follows.
Place the throttle dial midway between the “SLOW”
and the “FAST” positions.
(1) Throttle dial (A) “FAST”
(B) “SLOW”
6. Insert the key into the key switch. Turn the key
switch to the “START” position and release the key
to the “ON” position when the engine starts.
(See Key switch on page 29.)
IMPORTANT :
• Because of the start interlocks, the engine
can not be started except when the PTO
switch is disengaged (OFF), the parking
brake lock pedal is applied, motion control
levers are in “NEUTRAL LOCK” position and
the operator is sitting on the seat.
7. Make sure that the Easy Checker
™
lights have
gone off. If the light is still on, immediately stop the
engine and check the remedy following the
instruction.
(See CHECK DURING OPERATING on page 30.)
8. Warm up the engine by running at medium speed.
1. Throttle dial
Turn the throttle dial counterclockwise to decrease the
engine speed. Turn it clockwise to increase the engine
speed.
2. Key switch
OFF
The position where the key can be inserted into or
removed from the key switch. When the key is
turned to this position, the engine shuts off.
ON
The engine keeps running.
START
Apply the parking brake and turn the key switch to
this position to start the engine.
STARTING THE ENGINE OPERATING THE ENGINE
Z751KWi,Z781KWi,Z781KWTi
29