Kubota Z751KWi, Operator'S Manual

Page: 35 / 102

IMPORTANT :
• Do not use starting fluid or ether.
• To protect the battery and the starter, make sure
that the starter is not continuously turned for
more than 10 seconds at a time.
If the engine does not start, allow a 60 seconds
cool down period between starting attempts.
• If the starter does not turn the engine over, shut
off the starter immediately. Do not make further
attempts to start the engine until the condition
is corrected.
Consult your local KUBOTA Dealer.
• Do not turn the key switch to the “START”
position while the engine is running.
• When the temperature is below 0 ℃ (32 ℉ ), run
the engine at medium speed to warm up the
lubricant of the engine and the transmission for
at least 10 minutes. If the machine is operated
before the lubricant is warm enough, the
machine operating life will be shortened.
• Do not operate the machine under full load until
it is sufficiently warmed up 2 or 3 minutes for
temperature above 0
℃ (32 ℉ ).
• When the ambient temperature is less than
-15 ℃ (5 ℉ ), remove the battery from the
machine and store it somewhere warm until the
next operation.
CHECK DURING OPERATING
IMPORTANT :
Immediately stop the engine if:
• The engine suddenly slows down or
accelerates.
• Unusual noises suddenly occur.
• Exhaust fumes suddenly become discolored.
While operating, make the following checks to see that
all the parts are functioning normally:
• Easy Checker
™
on page 30
(1) Easy Checker
™
1. Easy Checker
™
If the warning lamps of the Easy Checker
™
come on
during operation, immediately stop the engine, and find
the cause as shown below.
Never operate the machine while Easy Checker
™
lamp
is on.
(1) Fuel level warning lamp
If the fuel in the tank goes below the prescribed
level, the warning lamp in the Easy Checker
™
will
start blinking.
If this should happen during operation, refuel as
soon as possible (within 20 minutes).
(See Checking the amount of fuel and refueling on
page 58.)
IMPORTANT :
• When the fuel warning lamp lights up, refuel
the tank as soon as possible. If the machine
runs out of fuel and stalls, the engine and its
components may be damaged.
(2) Engine overheat warning lamp
If the engine temperature gauge reads an unusual
level and the warning lamp in the Easy Checker
™
comes on, the engine may be overheated.
Stop machine operation.
OPERATING THE ENGINE CHECK DURING OPERATING
30
Z751KWi,Z781KWi,Z781KWTi