Kubota Z751KWi, Operator'S Manual

Page: 36 / 102

Check the machine by reading the troubleshooting
section of this manual.
(See ENGINE TROUBLESHOOTING on page
88.)
(3) Engine master warning lamp
If the engine has a malfunction, the engine master
warning comes on.
(4) Electrical charge warning lamp
If the alternator is not charging the battery, the
warning lamp in the Easy Checker
™
will come on.
If this should happen during operation, check the
electrical charging system or consult your local
KUBOTA Dealer.
(5) Engine oil pressure warning lamp
If the oil pressure in the engine goes below the
prescribed level, the warning lamp in the Easy
Checker
™
will come on.
If this should happen during operation, and it does
not go off when the engine is accelerated to more
than 1000 rpm, check level of engine oil.
(See Checking the engine oil level on page 57.)
(6) Master system warning lamp
If trouble should occur at the disconnection of fuel
sensor, or LCD monitor malfunction, the lamp
flashes as a warning. If the trouble is not corrected
by restarting the machine, consult your local
KUBOTA Dealer.
(7) Maintenance warning lamp
If maintenance is necessary, the maintenance
warning comes on. If you put a fuse in the empty
fuse box, this blinks.
NOTE :
• For checking and servicing of your machine,
consult your local KUBOTA Dealer for
instructions.
LCD MONITOR
(1) LCD monitor
1. Fuel gauge
When the key switch is on, the fuel gauge indicates the
fuel level.
Fuel gauge has 6 bars to show how much fuel remains
in the fuel tank.
If the fuel level is less than 1 bar, the warning light
starts blinking. Refuel within 20 minutes.
Be careful not to run the fuel tank completely empty.
Otherwise air may enter the fuel system.
Should this happen, the fuel system must be bled.
(1) Fuel gauge (A) “EMPTY”
(B) “FULL”
2. Engine temperature gauge
The engine temperature gauge has 6 bars to show how
hot the engine is.
If the bars are filled up and the engine gets even hotter,
all the bars will start blinking and the warning light will
turn on. Then park the machine and reduce engine rpm
to idle. To allow the engine to cool itself.
If the engine continues to get hotter, the engine will go
into a reduced power mode (engine rpm will
automatically reduce to low idle) to protect itself. Refer
to Kawasaki engine owner's manual for more details.
(1) Engine temperature gauge
3. Hour meter and code display
The hour meter has 3 display modes.
LCD MONITOR OPERATING THE ENGINE
Z751KWi,Z781KWi,Z781KWTi
31