Kubota Z751KWi, Operator'S Manual

Page: 65 / 102

2. Do not overfill past [MAX] line.
Oil expands with heat and may leak from cap during
usage if overfilled.
(1) Transaxle fluid expansion
tank
(A) [MAX] line
(B) [MIN] line
IMPORTANT :
• If the oil level is low, do not run the engine.
Add new oil into the expansion tank up to
the prescribed level.
• Do not overfill the expansion tank.
5. Checking the tire pressure
WARNING
To avoid serious injury or death:
• Park the machine on a firm and level surface.
• Apply the parking brake.
• Stop the engine and remove the key before
checking the tire pressure.
• Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
• Always maintain the correct tire pressure.
The inflation pressure in the front tires rises
quickly when using compressed air.
Do not inflate the tires above the recommended
pressure shown in the operator's manual.
IMPORTANT :
• Do not use tires larger than specified.
5.1 Inflation pressure
Even though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course
of time. Therefore, check it everyday and inflate as
necessary.
Z751KWi, Z781KWi
Tire sizes
Recommended inflation
pressure
Front
13 x 6.5 - 6, (non flat)
smooth
-
Rear 24 x 9.5 - 14, (4PR) turf
83 kPa
0.84 kgf/cm
2
12 psi
Z781KWTi
Tire sizes
Recommended inflation
pressure
Front
13 x 6.5 - 6, (non flat)
smooth
-
Rear 24 x 12 - 14, (4PR) turf
83 kPa
0.84 kgf/cm
2
12 psi
(1) Ground (A) “INSUFFICIENT”
(B) “NORMAL”
(C) “EXCESSIVE”
6. Checking the dial cam rotation
strength
WARNING
To avoid serious injury or death:
• Park the machine on a firm and level surface.
• Apply the parking brake.
• Disengage the PTO (OFF).
• Stop the engine and remove the key before
checking the dial cam rotation strength.
1. Raise the implement to the top position.
(See ADJUSTING THE CUTTING HEIGHT on page
46.)
2. Rotate the cutting height control dial and check for
smoothness.
PERIODIC SERVICE DAILY CHECK
60
Z751KWi,Z781KWi,Z781KWTi