Kubota WSM L3560, Workshop Manual

Page: 618 / 801

ELECTRICAL SYSTEM
L3560, L4060, L4760, L5060, L5460, L6060, WSM
9-M32
(Continued)
NOTE
• Display 1 : The trip meter can be reset to 0.0 h by pushing the display mode switch for about two seconds.
• Display 4 : The HST MODE, HST Response and Throttle-Up can be selected by pushing the display mode
switch for about two seconds. (HST only)
• Display 6 : The maintenance interval can be reset to 0 h by pushing the display mode switch for about
two seconds.
9Y1210824ELM0049US0
Display 1:
Hour meter /
Trip meter mode
• [HOUR meter]
Total operating hours are displayed.
• [TRIP meter]
Total operating hours, counted from the previous
resetting, is displayed.
• The hour meter indicates in six digits the hours the
tractor has been used; the last digit indicates 1/10 of
an hour.
Display 2:
Fuel consumption
mode
• Average fuel consumption is measured per hour from
the previous resetting.
• Total fuel consumption is measured from the
previous resetting.
• Hold down the Display mode button, and the setting
is reset to "0".
Display 3:
PTO speed mode
• The PTO speed is displayed when the PTO clutch
control switch is in "ON" position.
• When the PTO clutch control switch is in "OFF"
position, "OFF" is displayed.
Display 4:
HST mode
• [HST only]
The HST mode, Response and Throttle-UP settings
get displayed.
Display 5:
PM buildup mode
• Displays the PM buildup inside the DPF muffler.
• Regeneration is needed when the 100 % level has
been reached.
• The more the bar is extended to the right, the more
PM builds up.
Display 6:
Service inspect
mode
• The time elapsed since the previous engine oil
change gets displayed.
KiSC issued 03, 2016 A