Kubota WSM L3560, Workshop Manual

Page: 424 / 801

TRANSMISSION
L3560, L4060, L4760, L5060, L5460, L6060, WSM
3-S105
Separating Engine from Clutch Housing
1. Place the disassembling stands under the engine and clutch
housing.
2. Remove the engine and clutch housing mounting screws and
nuts.
3. Separate the engine from clutch housing.
(When reassembling)
• Apply grease to the spline of clutch shaft.
• Apply liquid gasket (Three Bond 1211 or equivalent) to joint face
of the flywheel housing and clutch housing.
9Y1210824CLS0025US0
Separating Clutch Housing and Mid Case
1. Remove the clutch housing and mid case mounting screws and
nuts.
2. Separate the clutch housing (1) and mid case (2).
(When reassembling)
• Gasket should be replaced with new one.
• Apply liquid gasket (Three Bond 1208C or equivalent) to joint
face of the clutch housing (1) and mid case (2).
• Make sure to apply liquid gasket to elongated grooves (3) on the
mid case face and to those on the lower side of the clutch
housing face.
9Y1210824TRS0091US0
Tightening torque
Engine and clutch housing
mounting screw
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
Engine and clutch housing
mounting nut
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
Tightening torque
Clutch housing and mid
case mounting nut
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
Clutch housing and mid
case mounting screw
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(1) Clutch Housing
(2) Mid Case
(3) Elongated Groove
KiSC issued 03, 2016 A