Kubota WSM L3560, Workshop Manual

Page: 702 / 801

ELECTRICAL SYSTEM
L3560, L4060, L4760, L5060, L5460, L6060, WSM
9-S64
Seat Tilt Switch
1. Disconnect the seat tilt switch connector (2).
2. Measure the resistance between connector terminal as shown
in the table below.
3. If the switch is damaged, replace it.
9Y1210824ELS0070US0
(4) Starter
Starter Motor B Terminal Voltage
1. Measure the voltage across the
B
terminal and chassis.
2. If the voltage differs from the battery voltage, check the battery's
cable.
9Y1210824ELS0071US0
Motor Test
CAUTION
• Secure the starter to prevent it from jumping up and down
while testing the motor.
1. Disconnect the battery negative cable from the battery.
2. Disconnect the battery positive cable and the leads from the
starter.
3. Remove the starter from the engine.
4. Disconnect the connecting lead (2) from the starter
C
terminal
(1).
5. Connect a jumper lead from the connecting lead (2) to the
battery positive terminal post.
6. Connect a jumper lead momentarily between the starter motor
housing and the battery negative terminal post.
7. If the motor does not run, check the motor.
9Y1210824ELS0072US0
Reference between
connector terminal
When switch spring is
pushed
Infinity
When switch spring is
released
0 Ω
(1) Seat Tilt Switch (2) Connector of Switch Side
Voltage Factory specification Approx. battery voltage
(1)
C
Terminal (2) Connecting Lead
KiSC issued 03, 2016 A