Kubota WSM L3560, Workshop Manual

Page: 794 / 801

CABIN
L3560, L4060, L4760, L5060, L5460, L6060, WSM
10-S51
High Pressure and Low Pressure Pipes
1. Remove the outer roof.
2. Disconnect the high pressure pipe 2 (2), then cap the open
fitting immediately to keep moisture out of the system.
3. Remove the rubber and disconnect the low pressure pipe (1),
then cap the open fittings immediately to keep moisture out of
the system.
4. Remove the inner covers (3).
(When reassembling)
• Replace the rubber with a new one.
• Apply compressor oil (DENSO ND-OIL 8 or equivalent) to the
O-rings and be careful not to damage them.
9Y1210824CAS0086US0
(5) Removing Heater Hoses
Front Grill, Skirt and Bonnet
• See page 10-S35.
9Y1210824CAS0087US0
Draining Coolant
• See page 10-S34.
9Y1210824CAS0078US0
Hose Clamp
1. Remove the hose bands (1).
2. Remove the hose clamp (2).
NOTE
• Before disconnecting the heater hoses (3), put the parting
marks on the hoses for making proper reconnecting.
3. Disconnect the heater hoses (3), then remove them from under
the cabin.
(When reassembling)
• Connecting the heater hoses at their original position.
9Y1210824CAS0088US0
Tightening torque
High pressure pipe 2
retaining nut
11.8 to 14.7 N·m
1.21 to 1.49 kgf·m
8.71 to 10.8 lbf·ft
Low pressure pipe retaining
nut
7.90 to 11.8 N·m
0.806 to 1.20 kgf·m
5.83 to 8.70 lbf·ft
(1) Low Pressure Pipe
(2) High Pressure Pipe 2
(3) Inner Cover
(1) Hose Band
(2) Hose Clamps
(3) Heater Hoses
KiSC issued 03, 2016 A