Kubota WSM L3560, Workshop Manual

Page: 796 / 801

CABIN
L3560, L4060, L4760, L5060, L5460, L6060, WSM
10-S53
(6) Cabin Windshields
Preparation
1. Prepare the followings.
• Cutter knife
1 piece
• Scraper
1 piece
• Gun for coating
1 piece
• Sika Tack-Ultrafast or equivalent
• Gummed tape
• Sika-Activator
• Sika primer 209
• Shin Etsu silicon KE420
• Sika-cleaner 205
NOTE
• Sika product are made by Sika Corporation.
• Shin Etsu silicon KE420 is made by Shin Etsu Polymer
Corporation.
• These materials can't be provided by Kubota Corporation.
• Therefore, please find the local made equivalent materials
in your country and use them when you need.
9Y1210824CAS0090US0
Before Replacing Windshields (1)
[In case of using piano wire (When glass is clacked)]
1. Thread the piano wire from the inside of cabin. Tie its both ends
to a wooden blocks or the like. (See the left figure.)
2. Pull the piano wire inward/outward alternately to cut the
adhered part.
NOTE
• Do not let the piano wire make sliding contact with the edge
of glass plate forcibly.
[In case of using cutter knife (When glass is totally crushed
finely)]
1. Insert the knife (3) into the adhered part.
2. Keep the edge of knife blade square to the glass edge at the
part
"a"
. Slide the knife blade along the glass surface and the
edge. Pull the part
"b"
in the direction parallel to the glass edge
to cut them off.
NOTE
• Find a wider gap between the glass and body.
• Be careful of handling the cutter knife not to damage your
hand.
9Y1210824CAS0091US0
Before Replacing Windshields (2)
1. When the Sika Tack-Ultrafast or equivalent attached to the
cabin frame and the glass are reused, remove the bond clearly.
2. Clean the frame surface with Sika-Activator.
NOTE
• Remove the bond completely.
9Y1210824CAS0092US0
(1) Piano Wire
(2) Wood Peace
(3) Cutter Knife
(4) Pulling
KiSC issued 03, 2016 A