Konica Minolta bizhub 36, User Manual

Page: 77 / 195

bizhub 42/36 6-21
6.9 Settings - Comm. Settings 6
6.9 Settings - Comm. Settings
6.9.1 Line Settings (G3)
Configure line settings for sending fax.
ECM OFF
The Error Correction Mode (ECM) is turned off when sending data.
ECM is an error correction mode defined by ITU-T (International Telecommunication Union - Telecommuni-
cation Standardization Sector). Fax machines equipped with the ECM feature communicate with each other,
confirming that the data sent is free of errors. Thus, communication can be made free from disturbances due
to line noises, etc. If noises frequently occur, it may take a slightly long time to complete a communication
compared with ECM OFF. After sending has been ended, this machine automatically returns to ECM ON.
Reference
- This machine sends faxes in ECM ON unless ECM OFF is specified.
- This function cannot be used together with the polling RX function.
V34 OFF
V34 is a communication mode used for super G3 fax communication. When the remote machine or this ma-
chine is connected to a telephone line via PBX, however, you may not establish a communication in the super
G3 mode depending on telephone line conditions.
In this case, it is recommended that you turn V34 off to send data. After sending has been completed, this
machine automatically returns to the V34 mode.
Reference
- This function cannot be used together with the polling RX function.
Check Dest. & Send
The specified fax number is compared with the remote fax number (CSI) and data is sent only when those
fax numbers match. If they do not match, the communication will fail; therefore preventing a sending error.
Reference
- To check the destination and send, the fax number of the recipient's fax machine must be registered
with the recipient's fax machine.
6.9.2 Comm. Method (G3)
Allows to set the communication method.
Polling RX - Polling RX
A function available on the receiver's side to request a sender to send set documents or documents to be
transmitted through polling reservation in the sender's machine. This is convenient when communication
costs are to be borne by the receiver.
Select [Polling RX] and select the recipient.