Konica Minolta 7145, Instruction Manual

Page: 207 / 359

Copying Image in the Centre of Copy Paper (AUTO Layout)
(continued)
9-41
• Non-Image Area Erase will be selected automatically.
• When using the Dual Page with this function, the original smaller than the
selected paper size will be printed in the centre of the copy paper without
image division performed.
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and paper size on the Basic Screen.
• APS and AMS are automatically released, and 1.00 (100%) is selected
as a magnification ratio.
• Copy mode is automatically set to 1-1. When selecting 1-2 mode, Platen
store mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original(s) FACE UP in the document feeder or FACE DOWN
on the platen glass.
For details on positioning originals, see p. 3-2 to p. 3-6.
DO NOT close the RADF when Non-Image Area Erase is selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [ START ].
When the finisher / paper exit / inner tray capacity is exceeded due
to the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
The AUTO layout function may not operate properly if the lighting is directly
over the platen glass. In this case, consult your service representative about
an appropriate place for installation.
9
Applications
Reverse
Image
Non-Image
Area Erase
Dual Page
Image Insert
Booklet
Combination
Chapter
Sheet/Cover
Insertion
Application
Selection Screen
Repeat
Flip Side 2
Frame/Fold
Erasure
AUTO
Layout
Image Shift
Reduce &
Shift
Stamp
Overlay
OHP
Interleave