44
406388/F
Defining receiver parameters for the PI50 and PI60 Receiver Units
The
Receiver
dialog box allows you to set up the detailed parameters for the signal
reception. It allows you to "fine tune" the receiver for optimal performance. Sea
conditions vary, sometimes drastically. The acoustic conditions are also changing.
Prerequisites
• The TV80 software is installed on the Processor Unit.
• The new device is physically connected to the Processor Unit using a serial cable.
• The communication parameters required for the device interface are known.
• Without a valid license, your TV80 system will not show real time data from the
catch monitoring sensors.
Procedure
1
Open the
Setup
menu.
2
On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
3
Observe the
I/O Setup
page on the right side of the
Installation
dialog box.
Every interface is presented as a small "block diagram".
4
On the relevant serial line communication, select the receiver icon.
The
Receiver
dialog box opens.
5
Make the necessary adjustments. Refer to the product accompanying documentation
for more information.
6
At the bottom of the dialog box, select
Apply
to save your settings.
7
Select
OK
to close the dialog box.
Related topics
Receiver dialog box, page 294
I/O Setup page, page 236
Simrad TV80 Reference Manual
Summary of Contents for Simrad TV80
