406388/F
137
Configuring catch monitoring sensors’
parameters and defining their measurements
Topics
Configuring a PX family sensor for an SR type receiver unit, page 137
Configuring a PX family sensor for a PI type receiver unit, page 139
Configuring and setting up the catch monitoring sensors for different measurements,
page 141
Configuring a PX TrawlEye sensor, page 143
Adding more measurements to a PX family sensor, page 144
Entering the offset values for sensor measurements, page 146
Changing the configuration of a sensor, page 146
Checking and adjusting the range settings of a measurement, page 147
Configuring a PX family sensor for an SR type receiver unit
Catch monitoring sensors are delivered from Kongsberg Maritime readily set up
with common default settings. Each individual sensor can be configured to specify
its communication channel, which measurements to make and some other relevant
operating parameters.
Prerequisites
This procedure assumes that a suitable receiver unit has been connected to the Processor
Unit, and that all relevant communication parameters have been defined.
This procedure assumes that a sensor is connected to the computer with the configuration
cable.
Context
The configuration parameters available in the relevant configuration dialog boxes allow
you to set up which measurements the sensor shall make and which communication
channels it shall use for these measurements.
The specific measurements a sensor can make depend on its lid type, its physical location
on the gear, and on the type of receiver you use.
Procedure
1
Open the
Setup
menu.
Summary of Contents for Simrad TV80
