Kodak ESP 9 ALL-IN-ONE PRINTER - SETUP BOOKLET, Start Here Manual

Page: 139 / 164

Chapter 11
Kodak ESP 9 Printer User Guide 115
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following measures: 1) reorient or relocate
the receiving antenna; 2) increase the separation between the equipment and the receiver;
3) connect the equipment to a different outlet (on a circuit) than the one the receiver is
connected to; 4) consult the dealer or an experienced radio/TV technician for additional
suggestions.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. To ensure
compliance with FCC regulations, use only the shielded interface cables provided with the
product, or additional specified components or accessories that can be used with the
installation of the product.
FCC and Industry Canada
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to
the following two conditions:
1 This device may not cause interference.
2 This device must accept any interference, including interference that may cause
undesired operation of the device
This device has been designed to operate with an antenna having a maximum gain of
1.8dB.
Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The
required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the EIRP is not more than required for successful communication.
IC Radiation Exposure Statement
IMPORTANT NOTE:
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be installed and operated
with minimum distance 20 cm between the radiator and your body.
Canadian DOC Statement
DOC Class B Compliance—This Class B digital apparatus complies with Canadian ICES-
003.
Caution:
When using the Bluetooth interface with a Kodak printer, the
transmitter must not be collocated or operated in conjunction with any other
antenna or transmitter.