Kodak ESP 9 ALL-IN-ONE PRINTER - SETUP BOOKLET, Start Here Manual

Page: 122 / 164

Troubleshooting
98 Kodak ESP 9 Printer User Guide
5 Make sure your card shows up under Network Adapters.
6 Refer to the documentation that came with your card.
To check your LAN card (Macintosh)
1 Click the Apple icon on the Menu bar.
2 Select
About This Mac
and then click
More Info
. The System Profiler is displayed.
3 In the System Profiler, click
Network
.
4 Make sure your LAN card appears in the list.
Probable Cause 3
You do not have an active network connection.
Corrective Action
Check to see if you have an active network connection.
To see if you have an active network connection
Check the two Ethernet indicator lights on the top and bottom of the RJ-45 Ethernet jack
on the back of the printer. The lights indicate the following:
To establish an active network connection
1 Check the cable connections from the All-in-One printer to your gateway, router, or hub
to ensure connections are secure.
2 If the connections are secure, turn off the power on the All-in-One printer, and then turn
it on again. Press the
On/Off
button on the control panel to turn the printer off, and
press it again to turn it back on. Also, turn off the power on your router or hub, and then
turn it on again.
No TCP/IP
Probable Cause
Your Local Area Network (LAN) card is not installed properly.
Corrective Action
Make sure your LAN card is installed properly and set up for TCP/IP. See the instructions
that came with your LAN card.
Top light If this light is a solid green, the device is properly connected to the
network, and communications have been established. If the top light is
off, there is no network connection.
Bottom light This yellow light flashes when data is being sent or received by the
device over the network.