PROGram Command
PCR-WE Interface Manual
127
PROG:EDIT:PHAS:STOP
Sets the ending phase angle of the sequence step.
Command
PROGram:EDIT:PHASe:STOP <step_NRf>,<enable_boolean>,[<phase_NR3>]
PROGram:EDIT:PHASe:STOP? <step_NRf>
Parameter
<step_NRf>
Value: 0 to 599 Number of the step that you want to configure
Parameter
<enable_boolean>
Value:
ON(1)
Enables phase control
OFF(0) Disables phase control (default)
Parameter
<phase_NR3>
Value:
0.0 to 360.0
Ending phase angle (The default value is 0)
0 and 360 are the same.
Unit:
DEG
Example
PROG:EDIT:PHAS:STOP 1,ON,90
PROG:EDIT:PHAS:STOP? 1
Response
Returns the ending phase angle of the specified step in the following order.
Phase control enabled/disabled<NR1>, ending phase angle<NR3>