Keysight Technologies U3022BH10, User'S And Service Manual

Page: 62 / 124

Setting Option 129 Source Path
1. Restart the PNA to Standalone Mode, if it is in Multiport Mode. Refer to Figure 36
on page 46 .
2. Send command 0.0 and [Preset] the PNA-X.
3. Refer to "Interface Control Mode" on page 53 . Use the values listed in Table 11 to
set Port 1, 3, 5, 7, 9, or 11 as the noise source path.
The test set will not operate in multiport mode. Interface or SCPI C ontrol
Mode is required to set the Noise Source Path.
Table 1 1 Option 129 Source Path Test Set I/O Commands
Address Data Source Path
0.0 Standard Port 1
(Option 129 is not enabled)
0.8 Noise Source Port 1
0.9 Noise Source Port 3
0.10 Noise Source Port 5
U3022 B H10
Option 129 External Source Path
0.11 Noise Source Port 7
0.12 Noise Source Port 9
0.13 Noise Source Port 11
An 8 is added to the Data Value to activate the Option 129 switch, as
indicated in
Table 1 1 .
62 U3022BH10 User's and Service Guide