Keysight Technologies U3022BH10, User'S And Service Manual

Page: 23 / 124

System Setup, 14-Ports
U3022 B H10
Preparing the PNA-X Network Analyzer for Lock-Link Kit U3021-60005
1. Remove the feet from the bottom of the network analyzer. Refer to Figure 8 .
Figure 8 Rear Bottom Feet
Figure 9 Install Locking Feet
Standoffs (x2)
Feet (x4)
Locking Feet
(5023-0132)
Screws (0515-1619)
Included in package
2. Remove the two lower standoffs and screws (0515-1619) from the rear panel on the
network analyzer.
3. Install the two rear locking feet (5023-0132) using the included screws (0515-1619),
where the standoffs were removed. Refer to
Figure 9 .
Table 7 Table Top Setup Accessories, Ordered Separately
Description Part Number Qty
Screw Machine Pan Head, Torx-T15 M3.5 x 0.6, 8 mm LG 0515-1402 8
Lock-Link Clip 1600-1423 4
Lock-Link Kit U3021-60005 1
System Setup, 14-Ports
The following procedure provides instructions for stacking the PNA-X and Test Set on a table top.
If this is the case, you will need the Lock-Link accessories shown in
Table 7 below. Only interface
cabling is provided with the U3022BH10 Test Set as indicated in Table 1, page 11 . If you are
installing the equipment in a racked system cabinet, skip this procedure and go to "Interface Cable
Connection, 14-Port System" on page 25 .
U3022BH10 User's and Service Guide 23