170
Keysight N5990A MIPI M-PHY Receiver Test User Guide
5
HS Tests
Parameters
The parameters used in
Expert Mode
for this test, are as follows:
• CDR Loop Bandwidth (if CDR is selected in the Special Parameter
dialog, see
)
• CDR Peaking (if CDR is selected in the Special Parameter dialog, see
• CDR Transition Density (if CDR is selected in the Special Parameter
dialog, see
)
• CDR Loop Order (if CDR is selected in the Special Parameter dialog,
see
• Semi Automated Test
• Set Single Ended Amplitude
• Set Offset
• Prepare Length
• Stall Length
• Prepare Length Capability
• IBerReader Init Mode
• Lane Under Test Terminated
These parameters are listed in alphabetical order in
Dependencies
The calibrations required for this test are as follows:
• Reference Clock Calibration
• Level Calibration Terminated
Results
An example of a HTML Viewer for the Test 2.1.4-HS-RX Differential
Termination Enable Time procedure is shown in
. The results
comprise of the following:
• The common parameter list (in
Expert Mode
)
• A test data table
Summary of Contents for N5990A
