8.2. Leakage sensor rope (KLS03-ROPE)
The leakage sensor (KLS03) monitors leaks through the sensor electrodes at the bottom of the device.
In a room with several locations where leakages could occur, it is possible to cascade up to 5 KLS03 and
operate these at one AlarmManager or MultiSensor.
Alternatively a leakage sensor with a 10 / 20 meter rope is available. Here the whole cable serves as a detector
to detect leaks with a single sensor over a length of up to 20 meters.
The KLS03-ROPE works in the same way as the standard KLS03. It also has the sensor electrodes at the lower
side of the housing and also here a cascading of up to 5 sensors is possible.
The rope of the leakage sensor must be fixed to the floor. Recommended for this is the use of anchoring clamps
for single pipes with a drill hole diameter of 6mm and a clamping range of 3-13mm. The distance of the clamps
should be between 30cm and 50cm.
Page
(07-2018, subject to change)
kentix.com
44
L
e
a
ka
g
e
Se
n
so
r
Accessories
