6.7.3. Opening of the casing / replacement of battery
The board of the MultiSensor-Door is fixed in the lid of the casing which is placed on the bottom part. To open
the casing, press the latching lug on the bottom of the housing downwards and push the casing upwards. It can
then be easily taken off.
Take the battery out of the mounting and replace it with an equivalent type (see data sheet).
6.7.4. Adding a MultiSensor-Door
1. For adding a MultiSensor-Door to the AlarmManager‘s configuration, start the teach-in process in the Kentix
ControlCenter. Press the „learn button“ and keep it pressed.
After 3 seconds there will be a short buzzering. The button can then be released.
2. The sensor should appear in the list after approx. 15-20 seconds and is configured automatically.
3. The teach-in process is completed, when the sensor is marked in the list with a green checkmark.
4. For completion click on Apply to add the MultiSensor-Door to the devices list.
6.7.5. Settings
The MultiSensor-Door is configured by 3 simple settings for the door-opener contact, vibration and sabotage:
Magnetic door contact
The default setting is „arming - only if closed“ and „armed-active“.
With this settings an arming is only possible if the door or window is closed and the sensor has detected the
magnet. Arming attempts are otherwise directly terminated.
If the equipped door has to be opened during arming, the option „Arming“ must be changed to „Always arm“.
During this phase the door can still be opened. After the arming an alarm will be triggered when the door is still
open.
Vibration
For vibration a 3-step sensitivity can be selected. The vibration is used for the detection of burglary attempts.
Mainly the two levels „High“ and „Medium“ presuppose that there are no external influences on the sensor
which lead to false alarms.
NOTE!
The battery level of the MultiSensor-Door can be read out with the ControlCenter. At a low battery level an
alarm is sent via SMS and E-mail to all administrators. In this case replace the battery as soon as possible.
Please note that an active connection to an AlarmManager is required for the operation of the
MultiSensor-Door. If the MultiSensor is not configured on an AlarmManager or the connection is
interrupted, the battery in it will discharge much faster.
NOTE!
The MultiSensor-Door sends its data in a routine message every 5 minutes. Note that it can take up to 5
minutes after saving the data to the AlarmManager, until the sensors measurement values appear in the
ControlCenter‘s dashboard.
Page
(07-2018, subject to change)
kentix.com
38
Mu
lti
Se
n
so
rs
Sm
a
rt
Mo
n
ito
ri
n
g
