The single settings of a DoorLock’s configuration interface are described here:
Default teach-in DoorLock
When learning new RFID-Tokens for the users this device is always displayed at first in the selection.
Double authentication (IP Wall Reader only)
At an IP Wall Reader doors can be opened using a PIN code or RFID media.
Activating the option double authentication, both types of authentication will be required for a successful
opening.
Name
Enter a name for the DoorLock-device. Typically this corresponds to the installation place.
Couple Time
Select the desired time (3 / 6 / 12 seconds), for which a device shall stay engaged after a valid booking.
Booking switches Alarmzone
If desired, an arm-/disarm-switching of a Kentix alarm system can be triggered by a booking.
The AlarmManager communication has to be activated for this in the „Configuration“ section.
Choose the desired Alarmzone here. If no Alarmzone is displayed, press the refresh-button to update the zone
selection. The usage of the function is described on the next page.
Time control Active
A Kentix DoorLock component can be configured to stay permanently engaged. The door can then be opened
without a booking at the RFID reader.
For this operating mode a time profile can be chosen here which determines the times to which the door can be
opened without additional authorization. The time control mode is activated automatically without any
authorization.
Time control requires booking
When this option has been activated the time control function always has to be activated by a valid booking.
Otherwise an opening of the door is not possible.
Switch output on booking
The Kentix AccessPoint has 2 relay outputs. These can by switched/activated by a booking (e.g. in combination
with a wall reader), to control external components (motor locks, barriers).
You can choose between two switching outputs at the AccessPoint.
Assigned Network Camera
Configured network cameras can be assigned to a door. Each time a RFID card is read at this door, an SD card
recording of several images is triggered and linked to the logbook entry.
The settings for network cameras can be found in „Configuration“ -> „Network cameras“.
Access profiles
In the settings of a DoorLock-device a direct assignment to one or multiple access profiles can be made, if
profiles have already been configured.
Page
(07-2018, subject to change)
kentix.com
82
Sm
a
rt
A
c
c
e
s
s
