Kendrion 694 411 00, Instruction Manual

Page: 215 / 467

Kendrion Kuhnke Automation GmbH Counter2, Counter/Posi2
(E 747GB-V2)
215
17 May 2021
Counter 1 State
The status variables indicate the state of the counter. This applies to

events and

notifications that settings are being applied.
Variable Data type Explanation
Counting_1 BOOL Counter enabled
Referenced_1 BOOL
Reference function has been run.
Use ResetReferenced_1 to reset
Clockwise_1 BOOL Up-counting
Compared_1 BOOL
Reference value function has been run.
Use ResetCompared_1 to reset
Captured_1 BOOL
Capture function has been run.
Use ResetCaptured_1 to reset
CounterSet_1 BOOL Counter set to preset value
CompareSet_1 BOOL Reference value has been set
PresetSet_1 BOOL Preset value has been set
MaxSet_1 BOOL Final counter value has been set
OptionsSet_1 BOOL Counter 1 options accepted
OutputsOnErrorOff_1 BOOL Error switches off the outputs (release 3 or higher)
Counter 1 Error
Use these variables to indicate error states.
Variable Data type Explanation
OutputsForcedOff_1 BOOL
Outputs set to 0 after a module error auf 0 (release 3 or
higher)
Err_Reserved_1_x BOOL Reserved error bits
Readings of Counter 1
Counter 1 Set-points
The counter can be preset to various set-points. Use variable "SetValue_1" and the following control bits of
group "Counter 1 Control" to transfer the value of the variable to the relevant registers.
Variable Explanation
SetCounter_1 Accepts value as actual counter reading
SetCompare_1 Accepts value as the reference value
SetPreset_1 Accepts value as the preset value
SetMax_1 Accepts value as the final counter value

Check variable "SelectedValue" to find the actual counter readings currently used as presets.

Use variable "Select_1" to choose the value you wish to see in variable "SelectedValue".