MS48IP Programming Guide
23
LCR Activation:
The LCR parameters, which are set via the 8006-coded LCR facility, can be
activated or deactivated by this program.
8 0 0 6 9 P
Parameters:
P
:
0
LCR parameters are not active.
:
1
LCR parameters are active.
Automatic Line Check (Only for operator):
The line service state and the signalling parameter can be set automatically by the
system.
8 2 7 o r 7 4 7
Notes
1. Once activated, the lines will be out of service for a while. Therefore, make sure
that there are no ongoing external calls on the system before activating this
code.
2. Once activated, the dial tone detector starts to check the lines. Then, it puts the
lines with CO dial tone:
-
In Service For Incoming Calls Only
if they were
In Service For Incoming
Calls Only
before the service is activated,
-
In Service otherwise. These lines are also marked as
DP
or
DTMF
after
a signaling test.
On the other hand, lines without CO dial tone are put:
-
In Service For Incoming Calls Only
if they were marked
as In Service
before the service is activated.
-
Out Of Service
otherwise.
