MS48IP Programming Guide
2
GENERAL DEFINITIONS
Explanations of the programs have been presented in a constant format in this
guide.
Heading Line:
Name of the program is stated.
Definition:
Brief explanation of the program is stated. This section is omitted in
some programs, since it has been included in the sections for necessary
explanations and parameter definitions.
Program Codes:
Some extension and line parameters can be programmed by two
alternative ways. One of them is programming of a single line (extension or external
line) and the other is programming of line group. Thus, parameters related to an
extension or line can be programmed either one by one or in groups. The group
programming option of a program code is indicated by [9]. If “9” is dialed in the code
at the shown position, then the parameters given for the extension or line will be
valid for all the extensions or lines, starting from the given extension or line to the
last one. However, IP extensions/lines and analog extensions/lines cannot be
programmed together in groups all at once. That means; during the programming, if
an analog extension number is entered before ‘9’, the group programming does not
cover the IP extensions, only the analog extensions will be programmed. To
program the IP extensions in groups, the programming process must also be
repeated by entering an IP extension line before ‘9’.
Parameters:
Parameters related to programs are stated with their definitions. Some
of the parameters are “conditional” ones that are to be entered in connection with
some previous parameters. Those conditional parameters are indicated in braces: {}
Cancellation:
The codes that will cancel the given program are defined here.
Please note that this section is used only when the related program has different
activation and cancellation codes.
Default value:
Factory default initial values of program parameters are stated here.
Notes:
Additional constraints, warnings and information about the program are
stated.
