MS48IP Programming Guide
6
Entering Program:
The system exits the programming mode automatically, if no programming is
carried for one minute. In such a case, the system must be put in programming
mode, if exists extra programs must be entered and then the system must be put
out of programming mode.
While entering the program, it’s essentially important to enter parameters in correct
length. Otherwise, the program may be ineffective, or the system may not work as
desired at all, due to the erroneous entry.
Therefore, one should be careful about the length of parameters that have been
indicated in the program definitions. As can be seen in definition sections, lengths of
some parameters may be variable. If such parameters will be entered in a length
that is shorter than the length indicated as the maximum number of digits, then they
must be terminated with the “*” key. Because of that, the programming must be
done with a DTMF phone. If the exchange has previously been programmed, the
extension, whose phone the programming has been performed through, may not be
authorized to use the key “*”. In spite of this fact, the key “*” may be used while
entering the programs.
Internal dial tone is received upon proper completion of the programming;
otherwise, error tone is received. In such a case, the related program code should
be re-entered.
IMPORTANT NOTE:
IP extensions cannot enter any program listed below.
