MS48IP Programming Guide
66
Defining SIP Port Number:
For the SIP communication, SIP signaling port must be programmed. (When SIP
extensions establish a conversation among themselves, there is no need to be set
MGW card specifically.)
SIP signaling default port number of the system is coming as dynamic. If it is
required to be set as static, the desired port number can be defined by using this
program. This value can be displayed through System Administrator program.
8 7 7 6 6 5 2 S M P
Parameters
S
:
IP extension number
M
:
0
Static IP Mode
:
1
Dynamic IP Mode
P
:
Port number (in PPPPP* format)
Default Value
M=1.
Notes
1. Example: 8776 6 52 151 5000* is dialed to set the port number as ‘5000’ for the
IP extension numbered 151.
2. For S parameter, the number used while the IP extension is assigned into the
system must be entered.
3. While M=0, the entered SIP port number is compared with the SIP port number
of the extension sent during registration. If the numbers are different,
extension’s connection request is rejected.
4. While M=1, the SIP port number is not checked during registration and the sent
SIP port number of the extension is recorded as the current number. If the M
parameter is selected as ’1’, P parameter is not entered (programming will be
completed by the * key, instead of entering P parameter).
