30
VI User Manual | Impulse Ergo Pedelec
* All five LEDs flash quickly: The battery is empty and is
being switched off, or is overloaded.
•
If the battery is empty, it will work once again
briefly following a short period of rejuvenation and
will then switch back off. It must now be charged.
•
If the battery is overloaded, it will switch back
on after a short idle period and can then be used
normally.
** The first LED flashes quickly: A charging fault is present.
•
In that case, please remove the mains plug from
the socket and then plug it in again after a short
time. The charger performs a readjustment. In most
cases, this rectifies the fault.
•
If the LED continues to flash, overheating or under-
cooling of the battery may also be the cause. If, for
example, you charge the battery in a cold environ-
ment at a temperature below 0°C, or the battery
heats up to over 60°C during a long ascent, the
management switches off to protect the battery. In
such cases, the battery must be taken to a warmer
environment or cooled down.
•
If the LED still flashes, take the battery to your
specialist cycle shop and have it checked.
DISPLAY
BATTERY CHARGE STATE
•••••
5 LEDs light up
100-84%
••••
4 LEDs light up
83-68%
•••
3 LEDs light up
67-51%
••
2 LEDs light up
50-34%
•
1 LED lights up
33-17%
¡
1 LED flashes
16-0%
No LED lights up
0%
5 LEDs flash quickly
0% or overloaded *
1st LED flashes quickly Charging fault **
in a warm garage when the outside temperature
is low. In this case you should only fit the battery
on your bike just before using it.
›
If you are transporting your Pedelec by car, take
the battery out of its holder and transport it
separately.
›
The battery should ideally be stored for longer
periods with a charge state of 50% to 75% at a
temperature of +10°C.
8.4 Battery information system
There is a display panel on the outer face of the battery
with five LEDs and a red Push button. If you press the red
Push button, the LEDs light up. Information about the bat-
tery and its charge state is provided based on the number
of LEDs that light up and the way in which they light up.
Charge state and battery capacity indicator
8.4.1 Checking the battery charge state
If you press the red Push button, the LEDs light up and
display the current
battery charge state
.
Charging times at different temperatures
Battery may be
damaged
Optimum temperature
range for charging
operation
Long charging times
-10°C
0°C
10°C
20°C
30°C
40°C
50°C
Summary of Contents for Bosch Cruise
