JUMO flowTRANS MAG H01, Operating Manual

Page: 198 / 260

13 Technical data
198
13.4 Transmitter JUMO flowTRANS MAG 01
13.4.1 Electrical properties
13.4.2 Electrical isolation
Current output, digital output DO1, DO2 and digital input are galvanically isolated from the sensor input
circuit and each other. The same also applies to signal outputs of versions with PROFIBUS-PA.
13.4.3 Empty pipe detection
Requirements for the function:
• Conductivity of the medium to be measured of ≥ 20 µS/cm
• Signal cable length of ≤ 50 m (164 ft)
• Sensor without preamplifier
• Nominal width DN ≥ DN 10
13.4.4 Mechanical features
13.4.5 Temperatures
13.4.6 Protection type according to EN 60529
Voltage supply AC 100 to 230 V (-15 %/+10 %)
AC 24 V (-30 %/+10 %)
DC 24 V (-30 %/+30 %), harmonics < 5 %
Supply frequency 47 to 64 Hz
Excitation frequency 6.25 HZ, 7.5 Hz, 12.5 Hz, 15 Hz, 25 Hz, 30 Hz
(50/60 Hz voltage supply)
Power consumption Sensor including transmitter
AC S ≤ 20 VA (switch-on current 8.8 A at
AC 230 V)
DC P ≤ 12 W (switch-on current 5.6 A)
Electrical connection Screw terminals (maximum 2.5 mm² – AWG 14)
Compact design
Housing Aluminum casting, painted
Paint Paint coat ≥ 80 µm thick, RAL 5013 (cobalt blue)
Cable fitting Polyamide
Remote mount design
Housing Aluminum casting, painted
Paint Paint coat, ≥ 80 µm thick,
Middle part RAL 5013 (cobalt blue)
Front lid/rear lid RAL 5013 (cobalt blue)
Cable fitting Polyamide
Weight 4.5 kg (9.92 lb)
Storage temperature -40 to +70 °C (-40 to +158 °F)
Ambient temperature -20 to +60 °C (-4 to +140 °F)
Transmitter housing IP65, IP67 (NEMA 4X)