JUMO flowTRANS MAG H01, Operating Manual

Page: 151 / 260

151
8 Parameterization
The parameters for the filling function must be configured:
To display the data relevant to filling in the process display, one of the operator pages should be config-
ured accordingly in the "
Display " menu:
IMPORTANT (NOTE)!
To achieve a fast response time of the filling function, damping must be switched off. The filling time
should be > 3 seconds.
Menu/parameter Value range Description
Totalizer/ ...Batching
a
Damping OFF Switch damping on/off
Default setting: ON
Preset Batch Tot. - Sets the filling quantity.
The configured digital output is activated when the
defined filling quantity is reached.
Lag Corr. Mode Automatic/Manual Selects the after-flow quantity correction.
It takes a certain time to close the filling valve; this in
turn leads to an after-flow of the fluid although the fill-
ing quantity has been reached and the valve closer
contact is actuated.
"Automatic after-flow correction" corrects the defined
filling quantity by the after-flow quantity.
Lag Corr. Quantity -100,000 to +100,000 Manual input of the after-flow quantity
Batch Tot. Display only After starting filling, the quantity already filled is dis-
played here.
The Totalizer restarts at zero each time filling starts
and only counts up to the defined filling quantity.
Total Batch Counter Display only Total number of all fills
Reset Batch Counter. Reset filling totalizer to zero
Start/Stop Batching Manual start/stop of filling action.
Alternatively, the digital input can be used to start/
stop the filling action.
a
Only available for JUMO flowTRANS MAG S02/H02
Menu/parameter Value range Description
Display/...Operator pages/ Operator page 1 (n)
Display Mode 3 lines with 9 characters Configuration of the respective operator page
1st Line Flowrate [unit] Selection of the measured value displayed in the re-
spective line. You can choose between the variants
displayed in the value range.
2nd Line Number of fills
3rd Line Batch totalizer