JUMO flowTRANS MAG H01, Operating Manual

Page: 136 / 260

8 Parameterization
136
8.4.8 Menu: Diagnostics
Italics = Parameter can only be viewed in the "Advanced" password level
Italics = Parameter can only be viewed in the "Advanced" password level
Menu/parameter Value range Description
Diagnostics
Diagnostics Control
Selection of "Diagnostic Control" submenu
Diagnostics Values Selection of "Diagnostics values" submenu
Fingerprints Selection of "Fingerprints" submenu
Trend Selection of "Trend" submenu
Flowrate Alarm Selection of "Flowrate Alarm" submenu
Simulation mode Off, Flow Velocity,
Q [Unit], Q [%], IOut, Freq on
DO1, Freq on DO2,
Logic DO1, Logic DO2, HART
Freq, Digital In Manual simulation of measured values
The output values correspond to the set simulated
measured value. "Configuration" appears in the lower
display line. After the simulation is ended, simulation
mode is set back to "Off". The values specified in the
"Value Range" column can be simulated.
Output Readings Selection of "Output Readings" submenu
Menu/parameter Value range Description
Diagnostics/ Diagnostics Control
Empty Pipe Detector Selection of "Empty Pipe Detector" submenu
Sensor Measurements Selection of "Sensor Measurements" submenu
Gas Bubble Detector
a
Selection of "Gas Bubble Detector" submenu
Coating Detector
a
Selection of "Coating Detector" submenu
Cond. Detection
a
Selection of "Conductivity Measurement" submenu
Grounding Check
a
Selection of "Grounding check" submenu
TFE Detector Selection of "TFE Detector" submenu
SIL Detection Selection of "SIL Detection" submenu
a
Only available for JUMO flowTRANS MAG S02/H02