– 44 –
(16) Adjusting the looper thread cam
1. Adjust so that thread comes off from the highest place of looper thread cam
when needles come down
and the top end of left needle
aligns with the bottom surface of looper
. Then tighten setscrews
to
fix the looper thread cam.
2. Preventing thread winding around the looper thread cam (former type)
Adjust the clearance provided between the top end of section
A
of looper thread winding prevention plate
and the edge of looper thread cam
to approximately 0 to 0.3 mm (the plate should not come in contact
with looper thread cam
).
Standard Adjustment
Thread
To align
3. Preventing thread winding around the looper thread cam (new type)
Adjust the clearances to 0.5 to 1mm (to a degree not coming in contact with bobbin thread cam
and
metal cover
) between the tip of bobbin thread entanglement preventive cutter
and metal cover
and
between the end plane of cutter
and that of bobbin thread cam
.
0.5 to 1mm
Front view diagram
A
Side view diagram
0.5 to 1mm
Summary of Contents for MF-7800D Series
