– 7 –
1. When motion of thread is very rough, and stable seams can not be
obtained, there are cases where the condition can be improved by
the following threading.
(1) Wind thread around 1st thread guide
.
(2) Wind thread around the thread tension thread guide
.
2. When using more stretchable thread (wooly thread or the like), the
threading as given below does not make thread stretch and neat
seams can be obtained.
(1) Do not pass thread (for spreader) through spreader auxiliary
thread tension
.
(2) Do not pass thread (for spreader) through the thread tension
disk
E
.
(3) Do not pass thread through the looper thread small tension disk
.
o When threading is not properly
performed, not only sewing
trouble occurs, but also needle
breakage is caused. So, be
careful.
Adjustment Procedure
Results of Improper Adjustment
Do not pass thread.
Engraved marker line
Summary of Contents for MF-7800D Series
