– 12 –
(4) Adjusting the position of the thread receiver
1. Position of the needle bar thread take-up thread receiver (in case of standard seams)
(1) It is the standard that the height of needle bar thread take-up thread receiver
is in the position where the
bottom end of thread hole to the center of needle bar thread take-up
aligns with the top surface of needle
bar thread take-up thread receiver
when the needle bar is in its lowest position.
Standard Adjustment
Thread hole
Center of hole
This range
To align
1. Position of the rocking thread take-up thread receiver (in case of soft seams)
(In case thread is not passed through needle bar thread take-up
)
(1) It is the standard that the height of rocking thread take-up receiver
is in the position where the top
surface of rocking thread take-up receiver
is in the range of the center to the top end of thread hole
of
rocking thread take-up
when rocking thread take-up
is in its lowest position.
(For the details of the position of the illustration below, refer to
Rocking thread take-up receiver of 2.
CONFIGURATION OF THE MACHINE COMPONENTS.)
To align
Summary of Contents for MF-7800D Series
