– 160 –
(4) Table for 7800D-E10
Part No. : 40024948
3 x ø3.8 on the front surface, depth 10 (Drill a hole at the time of set-up).
(Rear roller mounting holes)
4 x ø3.4 on the bottom surface, depth 20 (Drill a hole at the time of set-up).
Installing position of stopper for drawed
(On the reverse side)
17 (penetrated)
JUKI logotype
Y-Y (3-places)
X-X
Z-Z
(Step mounting position).
Protruded mounting position
4 x ø8.4 (penetrated)
(Cushion rubber
mounting holes)
5 x ø2C (penetrated)
3 x ø3.8 on the bottom surface, depth 10 (Drill a
hole at the time of set-up).
(Bracket mounting holes)
2 x ø3.8 on the bottom surface, depth 10 (Drill a hole
at the time of set-up). (Bracket mounting holes)
Front
2 x ø3.8 on the (bottom) surface, depth 10 (Drill a
hole at the time of set-up).
(Push button switch mounting position)
2 x ø3.8 on the bottom surface, depth 10 (Drill a hole
at the time of set-up). (Bracket mounting holes)
(penetrated)
Summary of Contents for MF-7800D Series
