Johnson Controls YORK YK MaxE, Operation Manual

Page: 170 / 184

JOHNSON CONTROLS
170
FORM 160.54-O1
printers
If equipped with HIGH SPEED serial board:
SW1 - off (-) Low when busy
2 - off 1200 Baud*
3 - off 1200 Baud*
4 - on 1200 Baud*
5 - Not Used
6 - off no parity
7 - off Pin 20 & pin 11 act as busy line
•
WEIgH-TROnIX Printer
- IMP-24 Model 2600
SW1 - off 1200 Baud*
2 - on 1200 Baud*
Model 1220
- Configure Menu
Baud= 1200
Data Bits = 8
Stop Bits = 1
Hshake = Busy-Line
Cols = 32
Invert = No
Font = 5 x 8
Mag = None
- Custom Menu
Auto Seq = No
Zero = 0
Pound sign = #
_(Underscore)
Busy invert = no
Online/offline = yes
Ext Ch Set = no
Print ready = yes
Set Clock = Not Used
Reset Seq = Not Used
•
SEIKO
DipSW1 -1 = off Input-Serial
1-2 = on Printing speed high
1-3 = on Auto loading - on
1-4 = off Auto LF - off
1-5 = on Setting Command - Enable
1-6 = off Printing density - 100%
1-7 = on Printing density - 100%
1-8 = on Printing, density - 100%
DipSW 2-1 = on Printing Columns - 40
2-2 = on User Font Back-up - on
2-3 = on Character Select - normal
2-4 = off Zero - slash
2-5 = on International character set -
American
2-6 = on International character set -
American
2-7 = on International character set -
American
2-8 = off International character set -
American
DipSW 3-1 = on Data length - 8 bits
3-2 = on Parity Setting - no
3-3 = on Parity condition - odd
3-4 = on Busy control - H/W busy
3-5 = on Baud rate select - 1200*
3-6 = off Baud rate select - 1200*
3-7 = on Baud rate select - 1200*
3-8 = off Baud rate select - 1200*
* Settings shown for 1200 Baud. Other Baud rates can
be selected. Refer to Printer manufacturer’s manual
supplied with Printer.
CoNtroL CeNter setUp
Chiller ID
Access Level Required: OPERATOR
Using the COMMS Screen, assign an Identification
number to the chiller. This number will appear at the
top of each report.
Printer Setup
Access Level Required: OPERATOR
Using the COMMS Screen, the Control Center must be
configured to transmit data in the same format as the
Printer is configured to receive the data. The following
values must be entered.
•
Baud Rate - Set as desired. Value selected must be
the same as Printer configuration above.
•
Data Bits - 8
•
Parity - None
•
Stop Bits - 1