Jeep WRANGLER 2020, Owner'S Manual

Page: 35 / 548

GETTING TO KNOW YOUR VEHICLE 33
6. With the wiring harness open, pull straight
downward on the wiring connector to
unplug. Store the wiring connector in the
lower door basket.
7. With the door in the open position, remove
the check bolt from the door check
attachment on the body side (using a
#T40 Torx head driver).
Door Check (Detached)
8. With the door open, lift the door with the
help of another person, to clear the hinge
pins from their hinges and remove the door.
To Install The Front Doors
1. Locate the upper and lower hinge pins on
the door, and lower them into the body
hinges on the vehicle.
NOTE:
The upper hinge pin is longer, which can be
used to assist in guiding the door into place
during installation.
Hinge Pin Locations
2. With the door in the open position, align the
door check bracket with the hole on the
body side. Insert the check screw and
tighten using a #40 Torx head driver to
19.9 ft· lb (27.0 N·m).
3. Insert the upper and lower hinge pin screws
into the body hinges. Tighten the screws
using a #T50 Torx head driver to 3.8 ft· lb /
5.2 N·m.
CAUTION!

Do not close the door before reattaching
the door check to the body. Damage may
occur to the door check.

Do not overtighten Torx fasteners, damage
to the vehicle’s parts will occur.

Hinge pins can break if overtightened
during door install (Max Torque: 6.0 ft· lb/
8.1 N·m).
2
21_JL_OM_EN_EU_t.book Page 33