Jeep WRANGLER 2020, Owner'S Manual

Page: 20 / 548

18 GETTING TO KNOW YOUR VEHICLE
1. Remove the back cover of the fob by
inserting a flat-blade screw driver into the
slot on the bottom of the fob. Pry until the
cover unsnaps being careful not to
damage the seal. Proceed
counter-clockwise to pry the remaining
snaps until the battery cover can be
removed.
1-3 – Back Cover Pry Points
2. Remove the depleted battery by inserting a
small flat-blade screwdriver into the battery
removal slot and sliding the battery forward
and up being careful not to damage the
electronic board underneath.
Battery Replacement
3. Install the new battery into the key fob,
making sure the positive (+) side is facing
up. Slide the battery until it is seated
securely below the tabs.
4. Reassemble the back cover making sure it
is properly aligned before snapping it back
in place.
NOTE:
Used batteries may be harmful to the environ-
ment if not disposed of correctly. Always
dispose of used batteries by specialized battery
disposal container, or by taking used batteries
to an authorized dealer.
Programming And Requesting Additional
Key Fobs
Programming the key fob may be performed by
an authorized dealer.
NOTE:

Once a key fob is programmed to a vehicle, it
cannot be repurposed and reprogrammed to
another vehicle.
WARNING!

The integrated key fob contains a coin cell
battery. Do not ingest the battery; there is a
chemical burn hazard. If the coin cell
battery is swallowed, it can cause severe
internal burns in just two hours and can
lead to death.

If you think a battery may have been swal-
lowed or placed inside any part of the body,
seek immediate medical attention.

Keep new and used batteries away from
children. If the battery compartment does
not close securely, stop using the product
and keep it away from children.
21_JL_OM_EN_EU_t.book Page 18