Jeep WRANGLER 2020, Owner'S Manual, Page: 393 / 548

SERVICING AND MAINTENANCE 391
LED FRONT SIDE MARKER
Please see an authorized dealer for service.
See below steps to replace:
HALOGEN FRONT FOG LAMP
NOTE:
We advise referring to an authorized dealer for
service.
See below steps to replace:
1. Reach under the vehicle to access the
back of the front fog lamp.
2. Disconnect the wire harness connector
from the front fog lamp connector
receptacle.
3. Firmly grab the bulb by the two latch
features and squeeze them together to
unlock the bulb from the back of the front
fog lamp housing.
4. Pull the bulb straight out from the keyed
opening in the housing and then connect
the replacement bulb.
LED Front Fog Lamp
Please see an authorized dealer for service.
REAR TAIL, STOP, TURN SIGNAL, AND BACKUP
LAMP
See below steps to replace:
1. Remove interior trim panel cap to access
single retaining screw for tail lamp
assembly.
Trim Cap
2. Remove retaining screw and disconnect
electrical connector, then remove tail lamp
assembly from the vehicle.
NOTE:
If necessary, push in on the assembly tab
located inboard behind the lamp housing.
Retaining Screw
3. Remove the three screws from assembly
bracket to access bulb sockets.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
8
21_JL_OM_EN_EU_t.book Page 391