Jeep WRANGLER 2020, Owner'S Manual, Page: 92 / 548

90 GETTING TO KNOW YOUR VEHICLE
NOTE:

All hard top removal and installation instruc-
tions are applicable to both two and four door
model vehicles.

Images shown are of four door models, and
appearance of two door model components
may differ.

The left side panel must be removed before
removing the right side panel.
To remove the hard top front panel(s), proceed
as follows:
1. Fold down the sun visor against the windshield.
2. Turn the three L-shaped locks on the left
side panel (one at the front, the rear, and
outside), unlocking them from the roof.
Step Two
3. Unlatch the left side header panel latch
located at the top of the windshield.
Step Three
4. Remove the left side panel.
5. Repeat the steps above to remove the right
side panel.
Hard Top Panel(s) Storage Bag —
If Equipped
The Freedom Top panels storage bag allows you
to store your hard top panels. The storage bag
contains two compartments.
Lay the bag for the Freedom Top panels down
so the loops and hooks are facing upward.
Unzip the bag and fold back the outer flap.
NOTE:
Ensure the front panel latch is closed prior to
inserting the panel into the panels bag.
1. Insert the left side hard top panel into the
bag with the latches facing upward.
2. Unfold the black panel divider (ensure the
divider is laying flat).
3. Insert the right side Freedom Top panel into
the bag with the latches facing downward.
NOTE:
Ensure the front panel latch is closed prior to
inserting the panel into the bag.
1 — Header Panel Latched
2 — Unlatched Position
21_JL_OM_EN_EU_t.book Page 90