Jeep WRANGLER 2020, Owner'S Manual, Page: 87 / 548

GETTING TO KNOW YOUR VEHICLE 85
Step Seven
I
NSTALLING
T
HE
S
OFT
T
OP
1. If currently installed, remove the hard top
Ú
page 91.
2. Install the door rails, starting with the front,
followed by the rear on each side. For
instructions and appropriate torque specifi-
cations for the door rail Torx screws, see
Ú
page 99.
3. Install the rear retainers on each side of the
rear of the vehicle using the provided
#50 Torx head driver and ratchet. Refer to
the table below for recommended torque
specifications.
Step Three
CAUTION!
Do not overtighten Torx screws. Damage to
the retainers will occur.
Torque
Specification
For Torx
Screw
Maximum Minimum
119.5 in-lb
(13.5 N·m)
150.5 in-lb
(17.0 N·m)
106.2 in-lb
(12.0 N·m)
CAUTION!
Failure to follow the next steps could result in
damage to the Soft Top or vehicle.
2
21_JL_OM_EN_EU_t.book Page 85