Jeep WRANGLER 2020, Owner'S Manual, Page: 37 / 548

GETTING TO KNOW YOUR VEHICLE 35
Door Removal Warning Label
NOTE:

Doors are heavy; use caution when removing
them.

Hinge pin can break if overtightened during
door reinstall (Max Torque: 7.5 ft· lb/10 N·m).
For off-road driving tips, see
Ú
page 198.
1. Roll down the glass window to prevent any
damage.
2. Remove the hinge pin screws from the
upper and lower outside hinges (using a
#T50 Torx head driver).
NOTE:
The hinge pin screws and nuts can be stowed in
the rear cargo tray located under the rear load
floor.
Hinge Pin Screw
3. Slide the front seat(s) fully forward.
4. Pry open and remove the plastic wiring
access door from the bottom of the B-pillar.
Wiring Access Door
5. Unplug the wiring connector.
NOTE:
Squeeze the tab on the base of the wiring
harness. This will unlock the connector tab,
allowing the wiring connector to be unplugged.
Wiring Connector
WARNING!

All occupants must wear seat belts during
off-road operation with doors removed. For
off-road driving tips, see
Ú
page 198.

Do not store detached doors inside of the
vehicle, as they may cause personal injury
in the event of an accident.
2
21_JL_OM_EN_EU_t.book Page 35