120
Problems and Warning Signals
If a buzzer sounds and the right touch screen shows a warning sign, follow the guidance below.
Warning Sign
Cause
Try this
The start/stop button is pressed with the foot control
connected.
Disconnect the foot control.
The foot control is broken.
Contact the service center or the
store from whom the machine
was purchased.
The machine will stop if the buttonhole is sewn
without lowering the buttonhole lever.
Lower the buttonhole lever and
start the machine again.
The twin needle key is pressed when the twin
needle sign is indicated on the right touch screen.
Replace the twin needle with a
single needle and press the OK
key.
The machine is started with the feed dogs lowered. Raise the feed dogs unless you
want to sew with the feed dog
lowered.
The needle plate is removed.
The needle plate is not properly attached to the set
position.
Attach the needle plate.
Check if the needle plate is
attached properly.
Press down the needle plate
with your finger to snap it into
the set position.
The needle plate is removed with the needle plate
release dial.
Turn the needle plate release
dial at set position.
Attach the needle plate.
The machine stops due to overload.
Wait for at least 15 seconds to
restart. Remove tangled threads
around take-up lever, hook race
and automatic thread cutting
mechanism.
