3-7
GO
-KARTS
B
U
MPERBOAT
S
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com
503-304-8899
ENDURANCE CL
UTCH PLA
TES
TM
Put a light film of grease around the inner lip of the
seal to keep it from tearing during installation.
NOTE: Do not grease the outer lip of the seal with
grease. Use “Gasgacinch” on the outer diameter.
Evenly tap or press the seal into the hub. Use a thin
coat of “Gasgacinch” on seal outer diameter to help
installation and to aid retention when it sets up.
Insert the newly-packed bearing into the appropriate
race.
Install the front wheel bearing, thrust washer, and
castle nut. Torque the castle nut to 15 ft. lbs to seat
the wheel bearings. Then, loosen the castle nut to
the first available cross-hole that the cotter pin will
push through. The hub should rotate freely.
If the hub does not turn smoothly and freely at this
point, then back off the castle nut to the next avail-
able cross-hole. Using a drift punch, tap the head of
the cotter pin down into the castle nut. When com-
plete, the head of the cotter pin should be crushed
just slightly. Fold the front half of the cotter pin over
the spindle. Reinstall the dust cover.
Grease
Gasgacinch
Disc-lock Socket #1-60-A0311
