13-35
GO
-KARTS
B
U
MPERBOAT
S
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com
503-304-8899
ENDURANCE CL
UTCH PLA
TES
TM
Before installing the new controller, be sure to put
a film of thermal paste (J&J# 2-70-0112, dielectric
grease) on the back to help with heat transfer from
the controller to the board then follow the steps
above in reverse (see the wiring diagram below for
controller wiring).
This is the interconnect board cable. The
interconnect board cable takes the information
sent to the interconnect board and sends it to the
controller. On a separately excited motor (D&D or
other), the cable is directional. The end with the red
tag must be plugged into the controller, while the
end with no tag plugs into the interconnect board.
On a permanent magnet motor (ASMO or other),
the cable is not directional.
NOTE: This Molex-type plug utilizes very small
contacts that click into place when installed from
the back. On occasion, they can be installed and
not fully snapped into place, causing them to vibrate
out when the kart is driven. If you have any type of
intermittent problem that comes and goes, check
to see if any of the small terminals have slid out,
and therefore may not be making good contact with
the pins. The cable would not need to be replaced
if the terminal has pushed out: just carefully push
the terminal back into the housing until it snaps into
place.
Red tag
DIELECTRIC GREASE
#2-70-0112
