13-64
GO
-KARTS
B
U
MPERBOAT
S
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com
503-304-8899
ENDURANCE CL
UTCH PLA
TES
TM
SYMPTOM: 8 FLASHES= CONTROLLER OVER TEMPERATURE.
This code is generated when the controller is overheated. This can result from a few different possible issues. The
most common reason for the controller being overheated is directly related to the heavy motor cables. If there
is a bad crimp or wire failure, they can create heat which travels back to the controller. To repair this, closely
inspect all of the cables that are attached to the controller for signs of heat; replace any problem cables. If the
controller is ever replaced, it is important to apply thermal grease, otherwise known as “heat paste” or “thermal
paste” to the back of the controller (J&J #2-70-0112). This product will help the controller transfer the heat from
the controller to the large aluminum plate, which is designed to distribute the heat away from the controller.
One other problem to look for is excessive drag on the motor, causing the amperage to remain
very high when the kart is in operation. This can be a problem with the motor or axle, or can
even occur if the guest drives against the rail for an entire race. Be sure to inspect the kart closely
for a problem. Once the controller cools down, however, the code will clear itself.
KARTROL LOCATIONS
Pit sensor
Sensor wire
Receiver
(bodied go-kart)
Receiver
(Eagle/F-22 go-kart,
mounted under
wing. Wire runs
down wing support)
Motor wire
